Large Vinyl Decal Installation Instructions

Wax coated release liner.

Large vinyl decal installation instructions.

Place pieces of masking tape on top of the decal pre mask and surface to hold the decal in place. Here is the easy part. This decal application instruction printable is the perfect item to add to your adhesive vinyl decal orders. Maneuver the decal into position decal should float on the surface of the car because both decal and the surfaces should be wet.

Tape it in place using masking tape along the top edge of the. The actual vinyl graphic striping decal or lettering that is being installed. Measure with a ruler or measuring tape to make sure your decal is properly lined up. You can apply most smaller decals without using water but for large and very large stickers this trick is a life saver.

Then lay the vinyl on a flat surface and spray the adhesive side as you remove the backing. Peel the backing from the decal exposing the adhesive. Spray the back of the vinyl as you peel it back. When looking to start selling items with your silhouette or cricut adhesive vinyl decals are a great item to begin.

Once in place put a long piece of tape across the decal in the center as shown below. Completely clean and dry the desired application surface. If you do not know of a professional contact our customer service team who will be happy to help you find an installer in your area. Adhesive side of vinyl.

Do not excessively stretch vinyl during the application. Have your partner begin to lay the exposed portion of the vinyl decal down onto the window. Align the decal where you would like it to be. Place a piece of masking tape vertically down the center of the decal from top to.

Then simply apply the vinyl to the surface. Large vinyl decals tips and guides installing large vinyl graphics is not recommended if you do not have any prior experience. Vinyl graphics lettering together and in position during installation and application. It is simple to the point and will clearly direct your buyer on how to correctly and successfully apply a vinyl decal.

To apply using the application spray spray the surface thoroughly. The sticky adhesive side of the vinyl graphic that adheres to the surface. Continue peeling away 6 sections of the backing at a time as you squeegee from top to bottom. Place the decal on the car ensuring no part of the decal touches a try spot.

An extra set of hands is a good idea. Once the graphic is fully applied squeegee from the center toward the outer edges to remove air bubbles. Technique used is a vertical hinge and installing each sid.